NOTE:Youmaynowrollyourtractoroffthe
skid.Followtheappropriateinstructionbelow
toremovethetractorfromtheskid.
WARNING:Beforestarting,read,un-
derstandandfollowallinstructionsinthe
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Raise attachment lift lever to its highest
position.
2. Release parking brake by depressing
brake pedal.
3. Place freewheel control in disengaged
position to disengage transmission (See
"TO TRANSPORT" in the Operation sec-
tion of this manual).
4. Roll tractor forward off skid.
5. Remove banding holding the deflector
shield up against tractor.
Continue with the instructions that follow.
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at
the factory for shipping purposes. Correct
tire pressure is important for best cutting
performance.
Reduce tire pressure to PSI shown on
tires.
CHECK DECK LEVELNESS
For best cutting results, mower housing
should be properly leveled. See "TO LEVEL
MOWER" in the Service and Adjustments
section of this manual.
CHECK FOR PROPER POSITION OF
ALL BELTS
See the figures that are shown for replacing
motion and mower blade drive belts in the
Service and Adjustments section of this man-
ual. Verifythat the belts are routed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor,
checkto seethat the brake is operating prop-
erly. See "TO CHECK BRAKE" inthe Service
and Adjustments section of this manual.
_fCHECKLIST
Before you operate your new tractor, we
wish to assure that you receive the best
performance and satisfaction from this
Quality Product.
Please review the following checklist:
J" All assembly instructions have been
completed.
J" No remaining loose parts in carton.
J" Battery isproperly prepared and charged.
J" Seat is adjusted comfortably and tight-
ened securely.
All tires are properly inflated. (For ship-
ping purposes, thetires were overinftated
at the factory).
J" Be sure mower deck is properly leveled
side-to-side/front-to-rear for best cutting
results. (Tires must be properly inflated
for leveling).
J" Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
Check wiring. See that all connections are
still secure and wires are properly clamped.
Before driving tractor, be sure freewheel
control isin "transmission engaged" posi-
tion (see "To Transport" in the Operation
section of this manual).
While learning howto use your tractor, pay ex-
tra attention to the following important items:
Engine oil is at proper level.
Fuel tank isfilled with fresh, clean, regular
unleaded gasoline.
Become familiar with all controls, their
location and function. Operate them
before you start the engine.
Be sure brake system isin safe operating
condition.
Be sure Operator Presence System and
Reverse Operation System (ROS) are
working properly (See the Operation and
Maintenance sections in this manual).
8
To Next Page
Loading...
Need help?
General
