Craftsman 919.155350 User Manual (English)

Questions and Answers:

S
Scott SmithJul 29, 2025
What to do if my Craftsman 919.155350 Paint Sprayer produces unatomized spray?
- B
  Bridget PerryJul 29, 2025
  If your Craftsman Paint Sprayer is producing unatomized or spattered spray, several factors could be at play. The material you're using might be too heavy; try thinning it or using a fluid nozzle set with a larger orifice. Also, check your air pressure; it might be insufficient, so increase it but stay within the recommended limits. The fluid pressure could also be too high, so reduce it. Finally, check for dried material on the tip of the fluid nozzle or air jets of the air cap and clean it off.
E
Eric BarkerAug 2, 2025
Why is my Craftsman Paint Sprayer spitting?
- J
  John RaymondAug 2, 2025
  If your Craftsman Paint Sprayer is spitting, spraying irregularly, or fluttering, here are a few things to check: 1. Make sure the fluid nozzle isn't cracked or worn. If it is, tighten or replace it. 2. If there's a leak at the fluid nozzle thread, tighten the fluid nozzle. 3. For leaks at the fluid needle, tighten the compression nut assembly or replace the needle packing. 4. If the needle packing is worn out, replace it. 5. Ensure you have sufficient fluid in the cup by filling it. 6. Check if the vent hole in the container cover is clogged and clean it out if necessary.
P
Patricia WilliamsAug 7, 2025
Why is my Craftsman 919.155350 Paint Sprayer leaking after I release the trigger?
- C
  Caitlin HerreraAug 7, 2025
  If you notice material leaking from the nozzle of your Craftsman Paint Sprayer after releasing the trigger, it could be due to a few reasons. The fluid needle might be worn, in which case you should replace it. There could also be dried material in the tip of the nozzle, so try cleaning it. Another possibility is a loose packing nut; tighten the needle packing nut by turning it counterclockwise.
M
Misty HigginsAug 10, 2025
Why is my Craftsman Paint Sprayer producing excessive fog?
- M
  Michelle Hogan DVMAug 11, 2025
  If your Craftsman Paint Sprayer is producing excessive fog, it could be because the air pressure is too high for the viscosity of the fluid you're using. Reduce the air pressure and/or open the fluid control knob.
N
Nicole FrancisAug 15, 2025
How to fix split spray pattern on Craftsman 919.155350 Paint Sprayer?
- J
  Joseph HallAug 15, 2025
  If your Craftsman Paint Sprayer's spray pattern is split, it's likely that the air pressure is too high. Try turning the pattern control knob clockwise to decrease the fan width and turn the fluid needle adjusting nut counter-clockwise to increase fluid flow.
M
Michael TorresAug 19, 2025
What to do if my Craftsman 919.155350 has inadequate air delivery?