Craftsman 944.361543 User Manual (English)

Questions and Answers:

J
Jose JonesAug 2, 2025
Why Craftsman Lawn Mower does not start?
- C
  colliernathanAug 2, 2025
  Your Craftsman Lawn Mower might not start due to several reasons: * A dirty air filter. Clean or replace it. * Lack of fuel. Refill the fuel tank. * Stale or water-contaminated fuel. Empty the tank and refill with fresh gasoline. * A disconnected spark plug wire. Connect the wire to the plug. * A bad spark plug. Replace the spark plug. * A loose or broken blade adapter. Tighten the blade bolt or replace the adapter. * The control bar is released. Depress the control bar to the handle. * A defective control bar. Replace it. * The fuel valve lever is in the OFF position. Turn it to the ON position. * A weak battery (if equipped). Charge the battery. * A disconnected battery connector (if equipped). Connect the battery to the engine.
M
Maria EwingAug 6, 2025
Why is my Craftsman 944.361543 losing power?
- K
  Kevin TaylorAug 6, 2025
  A loss of power in your Craftsman Lawn Mower can occur for several reasons: * The mower housing or blade is dragging in heavy grass. Raise the cutting height. * You're cutting too much grass. Raise the cutting height. * The air filter is dirty. Clean or replace it. * There's a buildup of grass, leaves, and trash under the mower. Clean the underside of the mower housing. * There's too much oil in the engine. Check the oil level. * Your walking speed is too fast. Cut at a slower pace.
I
iwongAug 10, 2025
What to do if Craftsman 944.361543 starter rope hard to pull?
- A
  Angel WellsAug 11, 2025
  If the starter rope on your Craftsman Lawn Mower is hard to pull, it could be due to: * The engine flywheel brake being on when the control bar is released. Depress the control bar to the upper handle before pulling the starter rope. * A bent engine crankshaft. * A broken blade adapter. Replace the blade adapter. * The blade dragging in grass. Move the lawn mower to cut grass or to a hard surface.
J
jonallenAug 14, 2025
Why Craftsman Lawn Mower poor cut uneven?
- J
  Julie RodriguezAug 14, 2025
  An uneven cut with your Craftsman Lawn Mower may be due to: * A worn, bent, or loose blade. Replace the blade and tighten the blade bolt. * Uneven wheel heights. Set all wheels at the same height. * A buildup of grass, leaves, and trash under the mower. Clean the underside of the mower housing.
D
dustin79Aug 19, 2025
Why is my Craftsman Lawn Mower vibrating excessively?
- J
  Jamie RodriguezAug 19, 2025
  Excessive vibration in your Craftsman Lawn Mower can be caused by: * A worn, bent, or loose blade. Replace the blade and tighten the blade bolt. * A bent engine crankshaft.
L
Lauren GordonAug 23, 2025
Why Craftsman Lawn Mower grass catcher not filling?
- J
  Jennifer ColemanAug 23, 2025
  If the grass catcher on your Craftsman Lawn Mower isn't filling, it could be because: * The cutting height is too low. Raise the cutting height. * The lift on the blade is worn off. Replace the blade. * The catcher isn't venting air. Clean the grass catcher.
E
Edward FosterAug 27, 2025
Why is my Craftsman Lawn Mower hard to push?
- D
  Daniel FernandezAug 27, 2025
  Your Craftsman Lawn Mower might be hard to push because: * The grass is too high, or the wheel height is too low. Raise the cutting height. * The rear of the mower housing or blade is dragging in grass. Raise the rear of the mower housing one setting higher. * The grass catcher is too full. Empty the grass catcher. * The handle height isn't right for you. Adjust the handle height to suit.

Craftsman 944.361543 Specifications

General

Brand	Craftsman
Model	944.361543
Category	Lawn Mower
Language	English

Summary

Safety Rules for Lawn Mower Operation

General Operation Guidelines

Read and follow all instructions before operating the lawn mower.

Slope Operation Precautions

Exercise caution when mowing on slopes to prevent slips and falls.

Child Safety Measures

Keep children away from the mower and be alert to their presence.

Service and Repair Safety

Follow safety procedures before performing any service or adjustments.

Assembly and Pre-Operation

Removing Mower From Carton

Instructions for safely unpacking the lawn mower from its shipping carton.

Setting Up Your Lawn Mower

Steps for unfolding the handle and assembling the grass catcher.

Operation

Know Your Lawn Mower

Familiarize yourself with the mower's controls and safety symbols.

Wear Safety Glasses and Use Mower Safely

Essential safety gear and basic safe operating practices for the mower.

Engine Speed and Control

Understanding engine speed settings and the operator presence control bar.

Adjusting Cutting Height

How to adjust the mower's cutting height for different lawn conditions.

Converting Mower and Emptying Grass Catcher

Steps for converting between mulching and bagging, and emptying the grass catcher.

Before Starting Engine

Add Oil and Gasoline

Proper procedures for adding engine oil and gasoline before operation.

Engine Starting and Stopping

Instructions for safely starting and stopping the lawn mower engine.

Mowing Techniques

General Mowing Tips

Advice for effective mowing under various grass conditions.

Mulching Mowing Tips

Best practices for mulching grass clippings for lawn health.

Maintenance

Maintenance Schedule

A schedule outlining regular service tasks for the lawn mower.

General Maintenance Recommendations

Key recommendations for maintaining the mower and preserving its warranty.

Lubrication Guidelines

Information on lubricating various parts of the lawn mower.

Product Specifications

Tire Care and Maintenance

Guidelines for maintaining the lawn mower's tires.

Blade Care and Replacement

Instructions for removing, replacing, and sharpening the mower blade.

Engine Maintenance

Engine Lubrication

Detailed steps for checking and changing engine oil.

Air Filter Maintenance

Procedures for cleaning or replacing the air filter for optimal engine performance.

Service and Adjustments

Component Servicing and Cleaning

Instructions for servicing the muffler, spark plug, and general mower cleaning.

Handle and Cutting Height Adjustment

Adjusting the handle position and cutting height for user comfort and performance.

Engine Speed Check

Information regarding factory-set engine speed and when to seek professional adjustment.

Storage Procedures

Preparing Mower for Storage

Steps to properly clean and prepare the mower for long-term storage.

Folding the Handle for Storage

How to safely fold the mower handle for compact storage or transport.

Troubleshooting

Engine Starting Problems

Common causes and corrections for the engine failing to start.

Performance and Cutting Issues

Troubleshooting for loss of power, poor cut, vibration, and grass catcher problems.

Repair Parts

Repair Parts Listing

A detailed list of part numbers and descriptions for mower components.

Engine Parts Diagrams and Lists

Exploded views and part numbers for the Briggs & Stratton engine.

Related product manuals

Craftsman 944.361543 User Manual

Table of Contents

Questions and Answers:

Craftsman 944.361543 Specifications

Summary

Safety Rules for Lawn Mower Operation

General Operation Guidelines

Slope Operation Precautions

Child Safety Measures

Service and Repair Safety

Assembly and Pre-Operation

Removing Mower From Carton

Setting Up Your Lawn Mower

Operation

Know Your Lawn Mower

Wear Safety Glasses and Use Mower Safely

Engine Speed and Control

Adjusting Cutting Height

Converting Mower and Emptying Grass Catcher

Before Starting Engine

Add Oil and Gasoline

Engine Starting and Stopping

Mowing Techniques

General Mowing Tips

Mulching Mowing Tips

Maintenance

Maintenance Schedule

General Maintenance Recommendations

Lubrication Guidelines

Product Specifications

Tire Care and Maintenance

Blade Care and Replacement

Engine Maintenance

Engine Lubrication

Air Filter Maintenance

Service and Adjustments

Component Servicing and Cleaning

Handle and Cutting Height Adjustment

Engine Speed Check

Storage Procedures

Preparing Mower for Storage

Folding the Handle for Storage

Troubleshooting

Engine Starting Problems

Performance and Cutting Issues

Repair Parts

Repair Parts Listing

Engine Parts Diagrams and Lists

Related product manuals