EasyManuals Logo

Craftsman CMCN618 User Manual

Craftsman CMCN618
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
ENGLISH
10
Fig.E
15
Loading and Unloading the Tool (Fig. F, G)
WARNING: Keep the tool pointed away from yourself
and others. Serious personal injury may result.
WARNING: Never load nails with the contact trip or
trigger activated. Personal injury may result.
WARNING: The battery should always be removed
and the trigger lock-off engaged whenever any
adjustments are made or when tool is not in use.
To Load the Tool
1. Press pusher latch
10
and pull magazine down.
2. Insert fasteners into the side of the magazine. Ensure
the fastener tips are placed towards the front of the
magazine, under the nail guide
16
in the nail channel.
3. Push magazine closed until it locks into place.
CAUTION: Keep fingers clear of pusher to
preventinjury.
To Unload the Tool
1. Press the nail pusher latch and pull the magazine down.
2. Tip the tool up until the nails slide freely out of
themagazine.
3. Open the jam clear door on the contact trip to verify
there are no nails remaining.
Fig.F
10
Fig.G
16
Using the Nailer
WARNING: The contact trip needs to be depressed
followed by a full trigger pull for each nail followed
by a release of both the contact trip and trigger after
each nail.
WARNING: The battery should always be removed
and the trigger lock-off engaged whenever any
adjustments are made or when tool is not in use.
1. Fully depress contact trip against the work surface.
2. Fully pull trigger and motor will start. (nail will drive into
work surface).
3. Release trigger.
4. Lift contact trip off work surface.
5. Repeat steps 1 through 4 for next application.
Worklights (Fig. H)
There is a worklight
5
located on each side of the nailer.
Worklights turn on upon depressing the contact trip.
NOTE: These worklights are for lighting the immediate work
surface and are not intended to be used as flashlights.
LOW BATTERY INDICATOR: The left-side worklight will
flash four consecutive times and then shut down to indicate
low battery.
JAMMED NAIL INDICATOR: The right-side worklight will
flash continually if a nail becomes jammed in the nosepiece
(see Clearing a Jammed Nail).
Fig.H
5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Craftsman CMCN618 and is the answer not in the manual?

Craftsman CMCN618 Specifications

General IconGeneral
BrandCraftsman
ModelCMCN618
CategoryNail Gun
LanguageEnglish

Related product manuals