What to do if Craftsman CMXCESM14143 Remote Starter turns on but won't jump start vehicle?
If your Craftsman Remote Starter turns on but won't jump start your vehicle, ensure the unit is adequately charged, with a charge level of at least 50%. Avoid attempting to jump start the vehicle more than three times consecutively. If the vehicle fails to start after these attempts, it is recommended to consult a qualified service technician.
What to do if Craftsman CMXCESM14143 green LED is blinking but there is no beep?
If the green LED is blinking and the red LED is off with no beep when the cable is correctly connected to both the battery and jump starter, it indicates that a "fake" high battery voltage is detected, but reverse charging protection did not activate. You can proceed to turn the key to jump start the vehicle.
What to do if the last LED flashes, then turns off on Craftsman Remote Starter?
If the last LED on your Craftsman Remote Starter flashes and then turns off, it indicates an over-discharge. You should recharge the internal battery.
Why are all four LEDs flashing on my Craftsman CMXCESM14143 Remote Starter?
If all four LEDs are flashing on your Craftsman Remote Starter, it indicates a low or high temperature condition. The LEDs will stop flashing once the temperature condition is corrected.
Explains safety alert symbols and words used in the manual to denote hazards.
Highlights the danger of explosive gases generated by batteries during operation.
Warns about the risks of electric shock and fire associated with the product's use.
Details precautions to prevent battery explosions and sparks near batteries.
Outlines safe practices for handling lead-acid batteries and preventing injury from acid or short circuits.
Warns about the corrosive nature of battery acid and necessary precautions during handling.
Advises on preventing sparks when connecting to a battery to avoid explosions.
Identifies and lists the main features and components of the jump starter unit.
Explains how to check the internal battery charge level using the unit's LEDs.
Provides instructions for charging the jump starter's internal battery using a USB cable.
Provides solutions for common problems encountered with the jump starter unit.
Explains the meaning of different LED patterns and alarms on the smart cable.
General| Brand | Craftsman |
|---|---|
| Model | CMXCESM14143 |
| Category | Remote Starter |
| Language | English |
To Next Page
