4
19) Outdoor antenna grounding
If an outside antenna is connected to the product, be sure the
antenna system is grounded so as to provide some protection
against voltage surges and built up static charges. Section 810
of the National Electric Code ANSI/NFPA 70 provides
information with respect to proper to grounding of the mast and
supporting structure, grounding of the lead-in wire to an
antenna discharge product,size of grounding conductors,
location of antenna discharge product,connection to grounding
electrodes and requirements for the grounding electrodes.
20) Service
Do not attempt to service this product yourself as opening
or removing covers may expose you to dangerous voltage
or other hazards, Refer all servicing to qualified service
personnel.
21) Replacement parts
When replacement parts are required, be sure the service
technician uses replacement parts specified by the
manufacturer or those that have the same characteristics
as the original parts. Unauthorized substitutions may
result in fire or electric shock or other hazards.
5
22) Safety check
Upon completion of any service or repairs to this product,
ask the service technician to perform safety checks to
determine that the product is in proper operation condition.
23) Wall or ceiling mounting
The product should be mounted to a wall or ceiling only as
recommended by the manufacturer.
24) Damage requiring service
Unplug this product from the wall outlet and refer service
to qualified service personnel under the following conditions.
a) When the power-supply cord or plug is damaged.
b) If liquid has been spilled or objects have fallen into
the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following
the operating instructions. Adjust only those controls
that are covered by the operating instructions,as an
adjustment of other controls may result in damage
and will and require extensive work by a qualified
technician to restore in the product to its normal
operation.
e) If the product has been dropped or the cabinet has been
damaged.
f) When the product exhibits a distinct change in
performance-this indicates a need for service.
25) Note to CATV system installer
This reminder is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC that provides guidelines
for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of
the-building, as close to the point of cable entry as
practical.
7
6
COPYRIGHT
Distributing copies of audio or video tracks without permission
is a violation of international copyright laws.
SAFETY:
Vibration experienced during walking or exercising will not
affect the player. However,dropping the player or dropping
a heavy object on the player may result in damage or sound
distortion.
Avoid spilling any liquid onto or into the player.
Do not leave the player in a location near heat sources; in a
location subject to direct sunlight,excessive dust, sand,
moisture, rain or mechanical shock; on an unlevel surface;
or in a car with the windows closed during periods of
excessive heat.
ROAD SAFETY:
Do not use headphones while driving,cycling or operating any
motorized vehicle. It may create a traffic hazard and it is
illegal in some areas. It can be potentially dangerous to play
your headset at a high volume while walking,especially at
pedestrian crossing. You should exercise extreme caution or
discontinue use in potentially hazardous situations.
FCC WARNING:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in a
accordance with the instructions,may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received,
including interference that may cause undesired operation.
Modification not authorized by the manufacturer may void
user’s authority to operate this device.
IMPORTANT SAFETY INSTRUCTION
PRECAUTIONS
PRECAUTIONS
IMPORTANT SAFETY INSTRUCTION
To Next Page
Loading...