EN
6
cramer.eu
WARNING!
To avoid serious personal injury, always remove the battery
pack from the tool when cleaning or performing any
maintenance.
Cleaning
Wipe the outside of the charger with a dry, soft cloth. Do not hose
down or wash with water.
Storage
Always remove the battery pack before storing the charger or any time
the charger is unplugged.
Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
Charger doesn’t
work. Charger
shows defective
mode (LED flashes
Red).
Battery pack
or charger is
defective or
bad connection
between the
battery pack and
charger.
Try to remove and
reconnect the battery pack
and the charger.
Try charging a different
battery pack.
Unplug the charger and
wait until the red LED goes
out, then reconnect the
plug to the power supply.
PROBLEM POSSIBLE CAUSE SOLUTION
Charger doesn’t
work. Charger
shows evaluation
mode (LED
indicates Red solid
ON).
Battery pack is too
hot or too cold.
Allow the battery pack to
reach normal temperature.
Charging will begin when
battery pack returns to
3°C-47°C (37°F-117°F).
Technical Data
PROPERTY VALUE
Model 82C2
Charger 82V charger
Input
230V 50/60Hz, 2.5A
Output 82V 4A
To Next Page
Loading...