Tank Assembly
• Locate and unwrap tank.
• Remove plastic plug from drain outlet.
***Important*** Rinse inside of tank with a hose to remove any plastic shavings draining
water through the outlet!
• Place the tank on the cart with the bottom outlet towards the handle.
• Locate plastic faucet and screw faucet into the tank.
• Using an adjustable wrench, tighten faucet assembly into tank fitting stopping when tight and
valve points down. *** Caution! Do not over tighten!***
• Push tank all the way onto cart.
• Install straps over the tank in the ridge areas of the tank tightening the straps securely.
• Place loose ends of the straps up under the top strap of the tank so they won't drag the
ground.
Parts and Assembly
10
PowerFlo ™ - Owner's Manual
To Next Page
Loading...