99999
9
Parts and Assembly
• Install the manifold on the poles inserting the brackets onto the poles.
***NOTE*** The inlet supply connector (the one with no hose attached) must be toward the
rear of the cart opposite the cart handle!
• Loosen the set screws in the brackets with the allen wrench so the manifold slips all the way over
the poles.
• Tighten set screws securely.
• To connect the fitting from supply hose to the manifold, insert connector, push up and rotate ¼ tur
n
t
o lock.
• Locate two plastic ties and secure the supply hose to the rail taking care not to tighten them too
much and kink the supply hose!
• The excess plastic ends of the wire ties can be cut off with scissors if desired.
PowerFlo ™ - Owner's Manual
To Next Page
Loading...