Manifold Assembly
• Locate aluminum support bracket (one is already attached to the front of the cart)
• Install bracket to the back of the cart with two 1/4 x 3/4" bolts and locknuts (see front bracket for
proper orientation) and tighten securely.
• Locate the two aluminum poles and place one end of the pole in each mounting bracket on the front
and rear rail of the cart.
• Loosen the set screws in the bracket with the supplied allen wrench until the pole slips all the way to
the bottom of the bracket.
• Tighten set screws securely against the pole with the allen wrench.
• Locate manifold with attached hoses.
8
Parts and Assembly
PowerFlo ™ - Owner's Manual
To Next Page
Loading...