1414141414
14
Maintenance / Storage
Maintenance/Storage
Draining Instructions
Draining your PowerFlo unit may be accomplished through two methods.
• Open the drain valve and allow the water to drain from the tank.
• Remove cap, un-strap and remove tank from cart and tip it over.
***WARNING***If cart is still attached damage may occur inside the cabinet and to the
manifold. Do not tip cart! Damages incurred from improper use are not covered by your
manufacturer’s warranty.
Cleaning and Storing
*** Note: PowerFlo 50 should be stored in a climate-controlled area. If this is not
possible, see winterizing instructions. ***
A filter is installed at the pump intake valve to prolong the life of the components and for added
health and safety of the user. This filter should be inspected and cleaned periodically during
normal use and maintenance. A dirty filter can cause unit not to work. To remove the filter for
inspection:
• Unscrew cap from the filter (right side of pump).
PowerFlo ™ - Owner's Manual
14
To Next Page
Loading...