Need help?Do you have a question about the Crate BX50 DLX and is the answer not in the manual?
General| Power Output | 50 Watts |
|---|---|
| Speaker Size | 12 inch |
| Channels | 1 |
| Weight | 40 lbs |
| Type | Bass Amplifier |
| EQ | 4-band |
| Inputs | 1/4 inch |
Read, follow, heed, and keep all instructions and warnings. Do not operate near heat sources or block ventilation.
Avoid liquids, use only lint-free cloths for cleaning, and connect to grounded outlets.
Protect power cords, unplug during storms, use specified accessories, and avoid exposure to moisture.
High sound pressure levels can cause hearing impairment; user caution and ear protection are advised.
Input jack for bass, Gain for distortion level, Shape for tone, and Level for output volume.
Channel switch, Level control for clean channel, and EQ for Low, Low Mid, High Mid, and High frequencies.
Octave control for lower pitch signal and Master control for overall output level.
CD Input, Headphones jack, Power switch, and built-in Electronic Tuner.
AC Line Cord, Footswitch jack for remote control, and External Speaker jack.
Recommended control settings for achieving a rock tone.
Recommended control settings for achieving a jazz tone.
Recommended control settings for achieving a country tone.
Recommended control settings for achieving a funk tone.
Recommended control settings for Solo Fuzz and Super Fat Fuzz tones.
Visual representation of signal path from input through processing to output.
Illustrates routing through Tuner, EQ, Distortion, Octave, Noise Gate, and Channel Switch.
Diagram shows connection to Power Amp, Speaker, External Speaker, and Headphones.
Output power, gain levels for channels, and CD input gain.
Frequency response details (Low, Low Mid, High Mid, High) and signal-to-noise ratio.
Input impedance, maximum signal accepted, and power requirements (voltage, frequency, VA).
Speaker size, type, magnet weight, voice coil size, RMS rating, and impedance.
Overall size (H x W x D) and weight of the amplifier units.
To Next Page
