Need help?Do you have a question about the Crate fxt120 and is the answer not in the manual?
General| output power rating | 120W RMS @ 5% THD, 4Ω, 120 VAC |
|---|---|
| speaker size and rating | (2) Custom Design 12”, 8Ω |
| input impedance | 470kΩ |
| maximum input signal accepted | 7 volts peak-to-peak |
| total system gain solo channel | 110dB |
| total system gain overdrive channel | 88dB |
| total system gain clean channel | 58dB |
| CD input | 29dB |
| O.D. channel low control | 20dB range @ 80Hz |
| O.D. channel mid control | 15dB range @ 1kHz |
| O.D. channel high control | 20dB range @ 10kHz |
| clean channel low control | 36dB range @ 80Hz |
| clean channel mid control | 15dB range @ 800Hz |
| clean channel high control | 40dB range @ 10kHz |
| power requirements | 120 VAC, 60Hz, 95VA, 100/115VAC, 50/60Hz, 95VA, 230VAC, 50/60Hz, 95VA |
Weight and Dimensions| size | 21” H x 26-1/2” W x 11” D |
|---|---|
| weight | 50 lbs. |
Connects guitar to amplifier via shielded instrument cable.
Adjusts light distortion for Overdrive channel when Gain Select is out.
Adjusts heavy distortion for Overdrive channel when Gain Select is depressed.
Dials tone for Overdrive channel Gain 2, affecting mid/high frequencies.
Selects Gain 1 or Gain 2 for Overdrive channel; inactive with footswitch.
Adjusts low and high frequencies for the Overdrive channel.
Adjusts the output level of the Overdrive channel.
Selects Clean or Overdrive channel; LEDs indicate active channel.
Adjusts the output level of the Clean channel.
Adjusts low, mid, and high frequencies for the Clean channel.
Controls the amount of digital effect mixed into the signal.
Selects one of the 16 built-in digital effects.
Connects external effects device into amplifier's power amp stage.
Turns the amplifier on or off; illuminates when power is on.
Provides real-time tuning with LED indicators for note and pitch.
Protects amplifier from power source issues; replace with same type.
Connects 1/4" stereo plug for remote channel/gain switching.
Connects 1/4" mono plug for remote DSP on/off control.
Connects to grounded outlet; ensure compatibility with codes.
To Next Page
