CRC SmartWasher SW-23 - Installation and Setup; 7.1. Mechanical Installation and Setup; Model SW-23 Mechanical Installation

Issue: Machine Does Not Heat (Part 3)
Process StepsProcess
Checkfor 120volts comingout of the circuit board at the connection terminals.
Unplug the 2black and 1yellow wires.
A
If 120volts is presentout of the top and bottomterminals,you will need to replace
the heaterelement.
B
If 120voltsis not present,check forvoltageacross the fuse. If blown,replacefuse
andheater. Heaterspecare 14.1ohms(+/- 1ohm) across 2blackwires.
C
If the fuse is goodand no voltagepresent, replacethe controlbox.
D
Inspectfront andbackof circuit board for discoloration or burn marks, if so
replacethe controlboardassemblyas well.
*
Heater Terminals
Top: (Line) Black
Middle: (Neutral) Black
Bottom: (Ground) Yellow
Heater Fuse
10 AMP Slow Blow
Step
4
8
Heater LED is on solidandthe
OzzyJuice®is cold.