Click "system setting" on the Device page, than click "firmware" . Download the right firmware from the
download link and click "upgrade" to finish the operation. "MX6600_CRScan_Ferret_App+Cfg_V1.1.6.bin"
firmware is needed for current PC
software version.
Setting before scan
Once connected successfully, the device is ready to scan. Press "Yes" on popup or on Device
page to enter the Project setting page. Configure the desired operational characteristics as described in
Section 3. Project settting of the UI Introduction.
① Name: Display the default name of the model to be created. Rename it as needed.
To Next Page
Loading...
