4
10
调平平台 2
Level Platform 2
10mm
10mm
If the platform does not stick to the print screen, do as the following:
如果没有贴紧打印屏，请进行如下操作：
2. Gently press the platform and tighten 4 screws clockwise, and the platform can be leveled
successfully.
3. Move up the z-axis to a proper position, remove the calibration card and install the resin vat back, and then tighten the fixing screws at
both ends of the resin vat.
Z :
0.10mm 1.00mm 10.00mm
Z : 0.10mm 1.00mm 10.00mm
1. After unscrewing the leveling screws, press“Home" to
keep the platform and the print screen parallel.
To Next Page
Loading...