Recycling of washing liquid: The following treatment method of washing liquid takes “alcohol" as an example. The filtered alcohol still has some resin dissolved in it, but it
can still be used to clean the model.
Daily Care
7
1. After washing about 30
models with the same barrel
of alcohol, the alcohol will
beco me more and more
turbid.Let the turbid alcohol
stand for about 10 hours to
allow the waste to settle.
2. Pour the standing upper
layer of alcohol into another
container, and then clean up
the bottom layer of waste.
(Exposure the waste to the sun,
wait until the alcohol is
completely volatilized, and after
the resin is cured, it can be
treated as ordinary solid waste)
3. After cleaning up the waste,
rinse the washing container
several times with water; if the
sediment at the bottom of the
washing container cannot be
washed away, you can remove
the stirring fan and scrub
separately. (For the method of
removing the stirring fan, see
the first step of “Cleaning the
stirring fan" on the next page).
4. After cleaning the washing
container, you can pour the
filtered alcohol into the
washing container again, and
cover the washing container lid
for the next time you clean the
model.
12
To Next Page
Loading...
General