10
ENGLISH
3. Gently move the loosened panel to the side of the purier body, then gently separate the
FFC cable buckle panel from the main body with your ngers and hold the panel open.
4. Take out the HEPA lter screen directly by pulling up with both hands, to put it back,
please note the direction of the arrow on the label on the lter screen.
5. Align the panel you just removed with the FFC cable and press the button.
6. Align the top position of the main part of the base with the panel rst, then gently press
down and check that the panel and the main part are installed successfully after hear-
ing a click.
7. Reset the power adapter (DC12V/2.5A) and press the boot key in the middle of the panel
after hearing two beeps.
To Next Page
Loading...