Create JET WASHER - Troubleshooting

16
ENGLISH
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous
substances in electric and electronic equipment as well as their waste disposal. The symbol with the
crossed dustbin shown on the package indicates that the product at the end of its service life shall be
collected as separate waste. Therefore, any products that have reached the end of their useful life must
be given to waste disposal centres specialising in separate collection of waste electrical and electronic
equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one
basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible nega-
tive effects on the environment and health and optimises the recycling and reuse of components making
up the apparatus. Abusive disposal of the product by the user involves application of the administrative
sanctions according to the laws.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
When the switch is in
the "ON/I" position,
the washer does not
work.
Electrical socket is faulty.
Voltage is inadequate.
Power cord is not plugged in.
Check plug, socket and fuses.
Check whether the voltage is adequate.
Plug in power cord.
The pump does not
reach adequate pres-
sure or uctuates.
Water inlet lter is clogged.
Pump is drawing air.
Suction valves are clogged/worn.
Diameter of garden hose is too
small.
Water supply is restricted.
Insufcient water supply.
Remove and clean lter.
Tighten connections/bleed system.
Clean or replace valves.
Replace with 0.75 inch garden hose.
Check hose for kinks or leaks.
Fully open the water source.
The pressure washer
has or will not main-
tain pressure.
Excessive air in waterline and pump. Turn unit and water supply off,
bleed the system or hold the trigger
down.
The motor stops run-
ning while in use.
Net voltage is lower than suggested. Check whether the voltage is adequate.