EasyManua.ls Logo

Create JET WASHER - Page 7

Create JET WASHER
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
ENGLISH
Do not use the appliance if a power cable or important parts of the ap-
pliance are damaged, e.G. Safety devices, high pressure hoses, spray gun.
If the extension cord is used, the plug and socket must be waterproof.
Warning: unsuitable extension cables can be dangerous, if an extension ca-
ble is used, it must be suitable for outdoor use, and the connection must be
kept dry and off the ground. The use of a power cable reel which keeps the
socket at least 60mm above the ground is strongly recommended.
Switch the appliance off and disconnect it from the power supply before as-
sembly, cleaning, adjustments, maintenance, storage and transportation.
The electric supply connection must be made by a qualied electrician
and comply with iec 60364-1. Either a residual current device that will cut
off the power supply if the leakage current to earth exceeds 30 ma for 30
ms or a ground fault interrupt device must be installed.
The washer is not suitable for connection to potable water pipes. Connect
the machine to the water supply.
Use the device on a at surface.
Keep good footing and balance at all times do not overreach or stand on
an unstable support.
The work area should have adequate drainage to reduce the possibility of
a fall due to slippery surfaces.
Do not use the pressure cleaner in areas near combustible materials, com-
bustible fumes, or dust.
For security reasons, make sure you have a three-month control and main-
tenance. Before use, make sure that the lter and the nozzle are not con-
taminated. After use, make sure there is no water in the pump and hose.
Overload protection: when the nozzle is stuffed or the high pressure hose
is knotted, the overload protection starts automatically and the machine
is switched off.
After solving the fault, turn the switch back on and turn the machine back on.
Warning: risk of explosion do not spray ammable liquids
Warning: high pressure hoses, ttings and couplings are important for the
safety of the machine. Use only hoses, ttings and couplings recommended
by the manufacturer
Some chemicals or detergents may be harmful if inhaled or ingested
causing severe injury. Use a respirator or mask whenever there is a
chance that vapors may be inhaled. Read all instructions included with
the mask so you are certain the mask will provide the necessary protec-
tion against inhaling harmful vapors.
Before starting the pressure washer in cold weather, check all of the
parts of the equipment and be sure that ice has not formed. Do not sto-
re the unit anywhere that the temperature will fall below 0 °C (32 °f).
Do not make any modications to any of the components! Units with
broken or missing parts, or without the protective housing or covers
should never be operated
Keep the high-pressure hose connected to the pressure cleaner and
the spray gun while the system is pressurized. Disconnecting the hose
while the unit is pressurized is dangerous, and may cause injury.
Always turn off the power when the machine is left unattended.
Keep water spray away from electrical wiring or fatal electric shock
may result.

Table of Contents