21
NOTES: The resultant field strength readings can vary significantly and will depend on how
much power the beacon is generating, the efficiency of the radiating source (antenna) and the
location of the beacon relative to the tester. Therefore, a specific reading of the measured
field strength can only be used by the individual running the test as a guide to tell if a real
problem exists with the beacon and its antenna system.
If using the test mode, the PLB signal is received by the satellite system however it is
disregarded and not processed when sent as a test message. When using the test mode
function of a PLB / ELT, the recycling function is not generated and is therefore unable to be
tested.
To Next Page
Loading...