Creative Engineering ROCK-A-FIRE EXPLOSION - Page 13

POWER DOWN PROCEDURES
A. Turn the House Lights to the Over-ride Mode.
B. Turn all four amplifier volume controls fully counter
clockwise and turn off power to the amplifiers.
C. Turn off the Equalizer.
D. Turn off Tape Decks #1 and #2.
E. Turn off
all power at panel L3.
1.
Gray Show Controller
2. Stage Flood Lights
3.
Audio
4. Stage Effect Lights
5. Spot Lights
6.
Drape Motors
F. Go to the Compressor room.
1. Turn off the Air Dryer
2. Turn off the Compressor
G. Empty all Drainage collectors, and check all drains for
blockage. Open the Drain Valves on the Compressor, Air Dryer
and Receiver a small amount, these valves will remain open all
night.
H. Check the Compressor oil level, if low add Non-Detergent oil,
fill to the proper level. (Note: Use 30wt. oil in the colder
areas, and 40wt. oil in the warmer areas.)
I. Check the Compressor for any loose components. ie, Belts,
Mounting bolts, fittings, etc., tighten any found.
J. If any problems are noted during the day, they are to be
documented and left on top of the Controller. This will insure
that the person coming in the next day will be aware of any
problems, before powering up the show.
K. Be sure the Controller and Compressor room doors are locked.
(Please Double Check the Doors)
(Note: Security policy may prohibit leaving the building during
night hours. Use the indoor shut off, and do the required steps
during power up procedures.)
1-004