Creative Engineering ROCK-A-FIRE EXPLOSION - Page 17

Weekly P.M. Cont.
Monthly P.M.:
K. The muffler is located at each character's
valve bank under the platform. Remove the bolt
holding the foam into the aluminum muffler.
Oil may have collected inside the muffler, remove
the foam and clean it and the muffler using water
and a mild soap. Allow the foam to dry completely
before reassembling.
L. Make sure all areas around the platform floor
lighting and electrical receptacles are free from
any debris. Wipe off the light lenses using
alcohol and a clean rag, Do Not disassemble the
lights to clean, all lighting should be cold
before cleaning.
A. Using the spare parts list, make a inventory of
all spare parts and ORDER replacements for any
missing parts. (See Pages 1-015 thru 1-017)
B. Clean all the spot lights using alcohol and a soft
piece of cloth. (Make sure the lights are cold
before cleaning)
C. Clean the compressor room, the compressor and air
dryer.
D. Clean the controller room.
E. Wipe down all props with a dampened sponge.
F. Clean and lubricate the drapery motors gear box,
and the main drive wheel.
G. Lubricate the drapery track, using silicone lube,
place lubrication only on the inside of the
aluminum channel. Check the curtain track mounting
in the ceiling.
H. Test the lights using the lighting video tape.
Replace any blown lamps. Adjust corresponding spot
light numbers, to their character positions. See
page 1-018 for an illustration of the characters,
with the spot light adjustments. The light can be
kept on by "Pinning Up" the appropriate bit.
(Refer to Electronics Repair, Pages 5-005 and
5-006, and all drawings referred to by that text)
1-008