Creative Engineering ROCK-A-FIRE EXPLOSION - Page 228

Symptom: One channel out
Procedure
2. Check meters on Amps.
3. Pull out the cable from
the channel in question
(1 or 2); switch the
cables around plugging
them back into the Deck.
4. Exchange input cables
on DBX.
5. Check fuse on speaker panel.
6. Check speaker.
7. Check fuses on rear of
amps.
Cont.
Result
If meters do not move, go to
step 7.
Problem does not travel with
the cable when exchanged -
deck is bad or tape, repair
or replace the bad part.
If problem does not move with
cable - then DBX is at fault,
replace it or see section on
DBX, pages 5-003 and 5-019
thru 5-025.
Replace if necessary.
Replace if necessary see page
5-003.
Replace any blown fuses and if
there is still no output,
replace amp/amps.
Symptom: Poor or Distorted Audio in both Channels
Procedure Result
1. Clean tape heads and
Demagnetize.
2. Pull out cables from
channels 1 & 2 of the
DBX box output and plug
them into channels 1 & 2
of the Tape Deck output.
3. Check gain and settings
of equalizer.
4. Check speakers.
5. Check wiring.
4-004
See Tape Deck Manual.
If sound comes out - DBX is
bad - replace it or see
section on DBX - pages 5-019
thru 5-025, and 5-003.
Reset or replace Equalizer.
See pages 5-002 and 5-017 or
5-018.
Replace if necessary, pages
5-003 and 5-015.
See pages 5-002 and 5-015.