To Next PageTo Next Page
Need help?Do you have a question about the Creator CRT-310-NR01 and is the answer not in the manual?
Specifies the voltage and tolerance for the device's power source.
Details idle and peak current requirements for the card reader.
Indicates the operational speed of the card reader mechanism.
Defines the communication interface used by the card reader.
Details the physical dimensions required for cards used with the reader.
Provides the weight of the card reader unit.
References the structural outline drawing for physical dimensions.
Specifies the performance standards for magnetic stripe card reading.
Outlines vibration and shock test parameters for device reliability.
Defines the expected operational life in cycles for key components.
Specifies voltage and time parameters for power down mode.
Quantifies acceptable error rates for mag-card and IC card operations.
Sets a limit for the acceptable abnormal height of warped cards.
Provides the Mean Time Between Failures for electric components.
Specifies operating and storage conditions for temperature and humidity.
Confirms support for IAP on-line download functionality.
States compliance with RoHS standards for materials.
Lists supported IC card standards and chip types.
References ISO standard for contactless IC cards.
Details physical, dimensional, and record format standards for magnetic cards.
Describes the position where the card is initially held.
Indicates the internal position where the card is read.
Specifies the position for IC card read/write operations.
Details automatic card reading and movement upon insertion.
Explains how magnetic stripe data is read and stored.
Describes the process for reading and operating with IC cards.
Covers RF operations for contactless IC cards.
Defines procedures for handling cards that deviate from ISO standards.
Explains how the reader manages power loss and backup power.
Describes the process for clearing errors using reset commands.
Illustrates the wiring for a single main power supply setup.
Details the connection for power backup with a capacitor.
Recommends maintenance intervals for sensors, heads, and contacts.
Safety instruction to disconnect power before initiating repairs.
Warning against disconnecting the serial port while powered.
Caution regarding the prevention of grease contamination.
Recommendation for power supply rating and a warning against overvoltage.
Procedure for safely disconnecting power before the serial port.
Reference to the DLL specification document.
Indicates availability of sample source code for DLLs.
Reference to the communication protocol documentation.
General| Brand | Creator |
|---|---|
| Model | CRT-310-NR01 |
| Category | Card Reader |
| Language | English |
