You can find your authorized Cressi-Sub center by
asking your dealer, or Cressi Sub S.p.A. itself
(email: info@cressi.com).
Inner components are in chromium-plated brass, stainless steel
and acetyl resins; springs are in stainless steel, diaphragms in sili-
cone, O-rings in NBR and the mouthpiece in comfortable
hypoallergenic silicone.
Cressi-Sub second-stage regulators meet the requirements set
by standard EU 250:2014 in compliance with regulation UE
2016/425 which sets out the conditions for bringing to market
and the minimal essential safety requirements of PPE. Conse-
quently, they bear the CE mark followed by the certifying agency
identification number 0474, identifying RINA, the registered test-
ing agency that monitors its manufacture pursuant to Form B+C2
of the EU 2016/425 regulation, as well as the critical health and
safety requirements for category III PPE. It also regulates the con-
ditions for bringing such equipment to market.
72
SECOND STAGES
To Next Page
Loading...