ENGLISH
WARNING: intermediate pressure adjustment should only
be carried out by authorised Cressi-sub centres and the cali-
bration values CANNOT and MUST NOT be changed by the
user, to avoid prejudicing the good working order of the regu-
lator. We cannot be held in any way liable for any intervention
carried out by staff unauthorised by Cressi-sub.
The Cressi-Sub authorised centres can be indicated
by retailers or, alternatively by Cressi Sub s.p.a.
(email: info@cressi.com).
The T10 first stage can therefore be used in cold water (with
water temperature below 10 °C/50 °F), since it complies with Di-
rective 89/686/EEC dated 21/12/1989, checked and certified by
Test Authority No. 0474 RINA located in Genoa, tested in compli-
ance with standard EN 250:2014 that establishes the require-
ments for Personal Protective Equipment (PPE) category III. It
therefore bears the CE marking followed by identification of the
certification authority (0474) that checks its manufacture pur-
suant to module B+C2 of EU Regulation 2016/425. The standard
also dictates the essential health and safety requirements for Cat-
egory III PPE and governs the conditions for bringing it to market.
The considerable technical solutions, combined with the high
quality of the materials used, ensure that this first stage regulator
is fully reliable and capable of providing the highest performance
extended over time.
Additional important information relating to our equipment can be
found on the website www.cressi.com
51
FIRST STAGES
To Next Page
Loading...
Need help?
General