To Next PageTo Next Page
Need help?Do you have a question about the Crest Audio VS SERIES - MANUAL 2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Impedance | 20kΩ balanced, 10kΩ unbalanced |
| Type | Power Amplifier |
| Total Harmonic Distortion | <0.1% @ 1kHz |
| Signal to Noise Ratio | >100dB |
| Protection | DC offset |
| Dimensions | 89mm |
Rack mounting ears and optional handles for installation.
Fan intake grill and exhaust ports for cooling.
LEDs for Signal, Clip, Active, and Protect status.
Front panel AC switch/circuit breaker for power control.
5-way binding posts for speaker connections.
Input attenuators and mode selection switch.
Balanced TRS and barrier strip connectors for audio input.
Details power requirements and circuit sizing for safe operation.
Explains the forced-air cooling system and ventilation needs.
Describes how to select between Stereo and Bridged Mono modes.
Automatically reduces gain to prevent loudspeaker damage from high power square waves.
Allows safe operation into loads as low as 2 ohms by adjusting channel gain.
