p. 2
Specifications
X-Monitor owner’s manual
+0/-1dB 20Hz–20kHz ref 1kHz—any input to any output
any output <.01%
THD 20Hz–20kHz @ +15dBu out
mic ein better-than -128dBu 20Hz–20kHz—150ohm source, 60dB gain
channel mute >80dB channel routing >80dB
channel fader attenuation >90dB aux send attenuation >75dB
< +/- 30 degrees,
20Hz–20kHz—mic-in to main-out
mic-in
XLR 4k ohm balanced—max voltage gain to group balanced out = 98dB
line-in
TRS >10k ohms balanced
left/right/mono—group, aux, matrix—monitor-out
all 100 ohms balanced
headphones to drive > eight-ohms
send 50 ohms ground-compensated on
TRS jack
return >10k ohms balanced on
TRS jack
+4dBu max level
+26dBu balanced into >1k ohms
high freq +/- 15dB shelf at
12kHz
hi-mid freq +/- 15dB bell freq range 400Hz–8kHz, Q=1.5
low-mid freq +/- 15dB bell freq range
80Hz–2kHz, Q=1.5
low freq +/- 15dB bell-boost /shelf-cut freq center
80Hz, Q=.7 on boost
high-pass filter -12dB/octave freq range
20Hz–400Hz
separate on-switches for eq and high-pass filter
five-band eq on all main outputs high-pass filter:-12dB/octave freq range
20Hz–400Hz
separate on-switches for eq and high-pass filter
five-segment
LED ladder with VU-type response—displays pre-fader signal level
top red-
LED warns of impending overload anywhere within the channel
fourteen mechanical
VU-type meters with LED illumination
twelve-meters showing group-out
two dedicated solo-meters
pink-noise generator can feed the talk-back section
chassis is powder-coated
14-gauge galvanized steel with internal-bracing
modules are powder-coated
18-gauge galvanized steel with baked-epoxy screening
see dimension-drawing
five-years
frequency response
THD
noise
crosstalk
phase shift
inputs
outputs
insert
nominal output level
input channel eq
output features
channel metering
master metering
signal generator
construction
dimensions and weights
warranty
To Next Page
Loading...
