4. Mounting
Mounting
Mounting
Mounting the
the
the
the thermo-hygro
thermo-hygro
thermo-hygro
thermo-hygro sensor
sensor
sensor
sensor to
to
to
to the
the
the
the third
third
third
third plastic
plastic
plastic
plastic bracket:
bracket:
bracket:
bracket: once the wind
sensors and rain sensor are fixed onto the bracket, connect the cables to the
corresponding thermo-hygro sensor sockets with the plugs, so that data can be
transmitted to the main unit ,then put the house-like cover onto the thermo-hygro sensor,
please follow the below display:
Note
Note
Note
Note : please don ’ t put in or take off the plug very of t en,or put the plug outside in the air
for a long time to avoid any damage of the plug , if so, there will be bad connection.
5.
5.
5.
5. Mounting
Mounting
Mounting
Mounting all
all
all
all the
the
the
the sensors
sensors
sensors
sensors onto
onto
onto
onto the
the
the
the stainless
stainless
stainless
stainless steel
steel
steel
steel mast
mast
mast
mast and
and
and
and fix
fix
fix
fix the
the
the
the whole
whole
whole
whole part
part
part
part at
at
at
at
outdoor
outdoor
outdoor
outdoor open
open
open
open area
area
area
area :(note:
:(note:
:(note:
:(note: please
please
please
please make
make
make
make sure
sure
sure
sure all
all
all
all the
the
the
the cables
cables
cables
cables are
are
are
are connected
connected
connected
connected well
well
well
well into
into
into
into
the
the
the
the sockets)
sockets)
sockets)
sockets)
To Next Page
Loading...
