Crestron C2N-AMP-6X100 - Connect Devices; Connect Audio Outputs

Connect Devices
The C2N-AMP-6X100 connects to a Crestron control system and Cresnet
devices over Ethernet or Cresnet.
LANPort
Connect the LANport to a LAN to communicate with a Crestron control
system over Ethernet.
NETPort
Connect the NETports to other Cresnet devices to communicate with a
Crestron control system over Cresnet.
Connect Audio Sources
ANALOG SOURCESIN 1 - 12 receive unbalanced analog audio through
RCAconnectors.
Connect Audio Outputs
ANALOG SOURCESOUT 1 - 12
ANALOG SOURCESOUT 1 - 12 are paralleled with their respective inputs
for connection to additional C2N-AMP-6X100 units or external audio
preamplifiers or receivers through RCAconnectors.
LINE OUTPUTS 5 and 6
LINE OUTPUTS 5 and 6 provide stereo line-level audio outputs through
RCA connectors. The outputs mirror the signals sent to SPEAKER
OUTPUTS 5 and 6.
ROOMOUTPUTS 7 and 8
ROOMOUTPUTS 7 and 8 provide stereo line-level audio outputs for
rooms 7 and 8 through RCA connectors.
SPEAKEROUTPUTS 1 - 6
Speakers outputs can be configured and wired for stereo, bridged stereo,
mono, or bridged mono operation. Each output's mode of operation is set
independently (unless it is part of a bridged pair) with Crestron
programming software such as SIMPLWindows. For details, refer to the
programming software's help file.
Stereo Operation
Use stereo operation to send a stereo signal to a speaker output with
separation of the left and right audio channels.
Connect a speaker output as shown for stereo operation.
Stereowiring
NOTE:When signals are routed to room 5 or 6, their respective LINE
OUTPUT connectors carry the same signals.
5
C2N-AMP-6X100 and C2NI-AMP-6X100
QuickStart
6-Room + 2 Audio System