Crestron DM-RMC-200-C Do Guide

DO GUIDE
DO Install the Device
The Crestron
®
DM-RMC-200-C mounts into a 2-gang electrical box using the included support
bracket. The support bracket provides a holder for the included power pack.
Mounting the Device into an Electrical Box
To mount the device into an electrical box, do the following:
1. Using the four included 6-32 x 3/4" combo truss head screws, attach the support bracket
to the electrical box.
2. Ground the DM-RMC-200-C and connect the proper cables to the bottom of the unit.
3. Using the four included 6-32 x 1" Phillips pan head screws, attach the DM-RMC-200-C to
the support bracket.
Inserting the Power Pack into the Power Pack Holder
To insert the power pack into the power pack holder, do the following:
1. Slide the power pack into the power pack holder.
2. Using the included 6-32 x 1/2” Phillips
pan head screw, thread the screw
through either of the two provided screw
holes to hold the power pack in place.
3. Bundle the excess cable of the power
pack into a loop, and then fasten the
bundled cable to the power pack holder
by doing the following:
a. Insert one of the included tie wraps
through one of the tie wrap holes in
the power pack holder.
b. Wrap the tie wrap around the
bundled cable.
c. Repeat steps 3a and 3b if
necessary using the other included
tie wrap and the remaining tie wrap
hole in the power pack holder.
DM-RMC-200-C
DigitalMedia 8G+
®
Receiver and Room Controller 200
DO Check the Box
QTY PRODUCT COLOR PART NUM.
1 Bracket, Support 2047590
2 Connector, 2-Pin 2003574
4 Connector, 2-Pin 2003582
2 Connector, 4-Pin 2003576
1 Connector, 5-Pin 2003577
1 Power Cord, 5' 10" (1.78 m) 2042043
1 Power Pack, 24 Vdc 2.5 A, 100-240 Vac 2045873
1 Screw, 6-32 x 1/2", Pan Head, Phillips Black 2007238
4 Screw, 6-32 x 1", Pan Head, Phillips Black 2007250
4 Screw, 6-32 x 3/4", Truss Head, Combo 2009211
2 Tie Wrap, Cable Tie, 15-1/2" x 1" Black 2013608
Tie wrap
hole
Tie wrap
hole
Screw
hole*
Screw
hole*
*Use either screw hole for the included
6-32 x 1/2" Phillips pan head screw.
DM IN:
From DM
®
switcher, transmitter, or
other DM device or from HDBaseT
®
device
DIG IN:
Software programmable
digital output
Ground
RELAY:
To relay
controllable
devices
AUDIO OUT:
Amplied stereo audio output

Crestron DM-RMC-200-C Specifications

General

Type	AV receiver
Material	Metal
Product color	Black
Maximum resolution	2048 x 1152 pixels
Maximum refresh rate	60 Hz
Ethernet LAN	Yes
RJ-45 input ports	1
Connectivity technology	Wired
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	47 mm
Width	276 mm
Height	202 mm
Weight	1480 g