DO GUIDE
DM-RMC-4KZ-100-C
DigitalMedia 8G+
®
4K60 4:4:4 HDR Receiver and
Room Controller
DO Connect the Device
Connect the device as required for the application.
Connections, Left Side
Connections, Right Side
NOTE: The DM IN port is a PoDM powered device (PD) port and is also compatible with HDBaseT
®
PoE.
In order to receive PoDM, the device must be connected to a DigitalMedia™ switcher or other
equipment that has a PoDM power sourcing equipment (PSE) port. In order to receive HDBaseT PoE,
the device must be connected to equipment that has a corresponding HDBaseT PoE PSE port.
Any wiring that is connected to a PoDM or HDBaseT PoE PSE port is for intrabuilding use only and
should not be connected to a line that runs outside of the building in which the PSE is located.
Connection to the included power pack is not required when PoDM or HDBaseT PoE is used to
power the device.
NOTE: The LAN port can connect to an Ethernet switch only when the DM IN port does not connect
to a DigitalMedia switcher.
DO Install the Device
The Crestron
®
DM-RMC-4KZ-100-C can be mounted onto a at surface or onto a rack rail.
Mounting onto a Flat Surface
Using four mounting screws (not included), mount the device onto a at surface such as a wall.
Mounting onto a Wall
Mounting onto a Rack Rail
The DM-RMC-4KZ-100-C mounts onto the front or rear rail of a rack. Position either of the two
mounting anges so that the holes align with the holes in the rack. Then, secure the device to the
rack using two rack mounting screws (not included).
Mounting onto a Rack Rail
DO Check the Box
QTY PRODUCT PART NUM.
1 Connector, 4-Pin 2003576
1 Connector, 5-Pin 2003577
1 Power Pack, 24 Vdc 0.75 A, 100-240 Vac 2045865
COM:
To RS-232
device
IR 1–2:
To IR
controllable
devices
LAN:
10BASE-T/
100BASE-TX
Ethernet to local
network device
Ground
DM IN:
From
DM
®
switcher,
transmitter, or other
DM device or from
HDBaseT
®
device
24 V
0.75A MAX:
From
included
power pack
HDMI OUT:
To HDMI
®
display
To Next Page
Need help?
General
