Installation Requirements
(con’t)
Cleaning Before Use
Wipe the inside of the freezer with a solution of mild detergent and water. Then rinse
with warm water using a damp sponge or cloth. Wash the baskets and shelves in warm,
soapy water and dry completely before replacing in the freezer. The external parts of
the freezer can be cleaned with wax polish.
Before Switching On!
LET YOUR REFRIGERATOR STAND UPRGIHT FOR APPROXIMATELY FOUR HOURS
BEFORE CONNECTING TO POWER.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait
30 minutes before switching back on to allow the coolant fluid to settle.
Door/Drawer Handle Installation
Set Screw
Inside
Set Screw
Bottom
Set Screw
Inside
Set
Screw
Set
Screw
Handle
Bracket
Handle
Pin
Handles
LOCATE AND REMOVE THE HANDLES AND PARTS POLYBAG
FROM THE INSIDE OF THE REFRIGERATOR.
1. Loosen the Set Screws in the
Brackets on one of the Handles.
Place the Handle over the two
Pins on the face of a door.
Secure in position by tightening Secure in position by tightening
the Set Screws in the Brackets
with the supplied Allen Wrench.
2. Repeat the process with the
other two Handles.
NOTE: The Handles should be
positioned so the Set Screws are
located toward the inside of the
located toward the inside of the
doors and the bottom of
the drawer.
Before Filling Your Freezer
Before storing foods in your freezer, turn the freezer on and wait 24 hours to make
sure it is working properly and to allow the freezer to reach the desired temperature.
8
To Next Page
Loading...
