11
Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety
information carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Package contents (Fig. A)
1 x telescopic pole (1)
2 x crossbar (2)
4 x hook (3)
1 x cap, slip-resistant (4)
4 x screw (5)
2 x washer (6)
4 x wall plug Ø 8/40 (7)
1 x hex key set (8)
1 x assembly instructions
1 x quick start guide
Technical data
Height variable from approx. 200-325cm
Max. frame diameter: approx. 50mm
30
Maximum load capacity: 30kg/crossbar
Date of manufacture (month/year):
05/2021
Intended use
The product is suitable as a bicycle stand for
bicycles with a maximum frame thickness of
approx. 50mm. The product has been devel-
oped for private indoor use. The product is not
intended for commercial use.
GB/IE
Safety information
Life-threatening hazard!
• Never leave children unattended with the pack-
aging materials. There is a risk of suffocation.
• The product is not a toy or a climbing appa-
ratus! Ensure that persons, especially children,
do not pull themselves up on the product or
stand on it. The product can tip over.
• WARNING! Do not exceed the maximum
permitted load capacity of 30kg per crossbar!
There is a risk of injury, or damage to the
product.
• Regularly inspect all parts of the product.
Loose screws must be re-tightened and defec-
tive parts must be replaced in order to prevent
damage to the product.
• Ensure that the slip-resistant caps have no
external damage. Defective slip-resistant caps
must be replaced.
• When drilling, pay special attention to electri-
cal lines as well as gas and water lines.
Risk of injury!
• Mind your fingers in particular when installing
the product. There is a risk of injury from
crushing.
• The product may only be used under adult
supervision and must not be used as a toy.
• Ensure the product is properly stabilised
before using it.
• Check that all parts have been properly
assembled before each use.
• Use all of the fastening materials listed in
the package contents to fasten the product.
Enquire at a specialist store about suitable in-
stallation materials if a different base structure
is to be used.
• Improper installation can impair the product’s
safety and functionality.
• Place the product on a flat, level surface.
• The product must not be installed on articles
of furniture.
• Check the product for damage or wear before
each use. Check regularly to make sure all
screws are tight! Only use the product if it is in
perfect condition!
To Next Page
Loading...
