To Next PageTo Next Page
Need help?Do you have a question about the Crivit AS- 5937 and is the answer not in the manual?
Adult assembly required due to small parts. Item is for single-person use only. Check for damage and tightness regularly.
Be aware of pinch points when folding/unfolding. Wear protective gear and shoes. Consider others and use on suitable surfaces.
Avoid water, oil, potholes, and very rough surfaces to maintain the item's condition.
Slide safety lever up, pull main lever, release safety lever, and fold steering column forward until it locks.
Remove grips, lift cover, press locking knobs, and push grips into T-tube until they audibly snap into place.
Loosen quick release, pull column up to desired height, ensuring locking knob engages a hole, then secure quick release.
Bearing is pre-set. Adjust by specialist if handlebars become loose or stiff for safe operation.
Fold kickstand. Push off with one leg to ride. Use brake plate to stop. Swing out kickstand to park on level surface.
Loosen axle bolts, remove wheel, install new wheel, secure with bolts. Check tightness and bearing noise after replacement.
Remove wheels, lever out old bearings and spacer, insert new bearings and spacer, then re-secure wheels.
Clean and dry after use. Remove debris, dry bearings, grease externally to prevent rust. Store in a dry place.
Dispose of the item and packaging according to local regulations. Keep packaging materials away from children.
Adult assembly required due to small parts. Item is for single-person use only. Check for damage and tightness regularly.
Be aware of pinch points when folding/unfolding. Wear protective gear and shoes. Consider others and use on suitable surfaces.
Avoid water, oil, potholes, and very rough surfaces to maintain the item's condition.
Slide safety lever up, pull main lever, release safety lever, and fold steering column forward until it locks.
Remove grips, lift cover, press locking knobs, and push grips into T-tube until they audibly snap into place.
Loosen quick release, pull column up to desired height, ensuring locking knob engages a hole, then secure quick release.
Bearing is pre-set. Adjust by specialist if handlebars become loose or stiff for safe operation.
Fold kickstand. Push off with one leg to ride. Use brake plate to stop. Swing out kickstand to park on level surface.
Loosen axle bolts, remove wheel, install new wheel, secure with bolts. Check tightness and bearing noise after replacement.
Remove wheels, lever out old bearings and spacer, insert new bearings and spacer, then re-secure wheels.
Clean and dry after use. Remove debris, dry bearings, grease externally to prevent rust. Store in a dry place.
Dispose of the item and packaging according to local regulations. Keep packaging materials away from children.
General| Type | Kick scooter |
|---|---|
| Maximum Weight Capacity | 100 kg |
| Foldable | Yes |
| Material | Aluminum |
| Brake | Rear foot brake |
