3" AIR SPACE
1"
Installation
CRATING
SCREW
Unpackingand Leveling- Upright Freezers
\
PLASTIC
HINGE COVER
Hinge Cover and Screws
Before starting the freezer, follow these important first steps:
Installation
• Choose a place that is near a grounded electrical outlet,
Forthe most efficient operation, freezer should be located where surrounding
temperatures will not exceed 110°F (43°C), Temperatures of 32°F (O°C)and
belowwill NOT affect freezer operation, Additional compressor heaters are
not recommended,
AIIowspace aroundthe unit for proper aircirculation, Leavea3 inch (75 mm)space
on all sides of freezer, for adequate circulation,
Leveling
Freezermust haveall bottom corners resting firmly on asolid floor, The floor must be
strong enough to support a fully loaded freezer, Check the cabinet with a level from
sideto side, After discarding crating screws and wood base,level the freezer cabinet,
Once leveled, slightly raise adjustment of front feet, so door closes easily
when opened about halfway,
Cleaning
• Wash any removable parts, and the interior and exterior with mild detergent
and warm water, Wipe dry, Do not use harsh cleaners on these surfaces.
, Do not use razor blades or other sharp instruments, which can scratch
the appliance surface when removing adhesive labels, Any glue left from
tape or energy labels can be removed with a mixture of warm water and
mild detergent, or touch the residue with the sticky side of tape already
removed, Do not remove serial plate.
Upright Freezer Door Removal:
If door must be removed:
1, Lift up plastic hinge cover, and fold back,
2, Usea Phillips® screwdriver to loosen and retighten screws on the top hinge, to
ensure a secure assembly, and prevent hinge slippage,
3, Remove top hinge from cabinet, and lift door off the lower hinge pin,
4, After door isremoved, remove the two screws from bottom hinge,
5, To replace door, reverse above order,
To allow door to
close and seal properly, DO NOT let
food packages extend past the front
of shelves.
Shelf Front
To Next Page
Loading...
Need help?
General
