55
45
11409
200103
11409
12203
41104
11209
41145
41324
41146
41324
11106
12203
12303
41144
11409
M4x11
41336
95032
11106
M3x8
11209
M3x14
11211
M3x18
11211
12203
M3
12303
M3
THREAD
LOCK
(Not included)
Servo arm installation
1. 1 Check to remote control's instruction for get servo using and setting method.
1.2 Make sure the servo is in neutral position before installation, as shown in the drawing to keep
the transmission rod in its state (low gear), the arm is mounted on the servo, and the servo
doesn't put pressure on the shift rod after installation completed
2. Adjusting servo stroke and result to spring decrement in the 2-3mm after into high speed gear.
Make sure the servo is operated in a suitable stroke, it's may result in damage to the servo or
transmission gearbox parts if the servo or shift rod continues to exert a large force.
WARNING
Servo stroke adjustment
Amount of compression 2~3 mm
Spring #1
Spring #2
Servo stroke
Nut
Transmission gear box
Servo arm
Transmission rod
Servo
20mm
a b
a<b
BAG(F)(J)
To Next Page
Loading...
