EasyManua.ls Logo

CROSS-RC EMO XL - EMOXL说明书20240419 Model (1)

CROSS-RC EMO XL
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTION
To prevent serious personal injury and/or property
damage,operate all remotely controlled models in a
responsible manner as outlined herein.
Safety Precautions
1.1 This radio-controlled model is not a toy, it is designed for persons 14
years of age or older.
1.2 Do not operate your vehicle on unsafe terrain; always pay attention to
your surroundings.
1.3 Never operate your vehicle on public roadways, around moving people,
animals, or operating machinery.
1.4 Keep clear of power lines and high-powered radio equipment to
minimize radio frequency interference.
1.5 Since this vehicle contains small components, it may be a choking
hazard for small children. Keep the vehicle and any spare parts out
of reach of small children.
Inspect your radio-controlled model before operation
2.1 Ensure that all screws are properly tightened. Use thread-lock to secure any metal
to metal contacts- especially for components designed to withstand torque
(servo mounts, motor mount, drive shaft grub screws etc.).
2.2 Always check the battery voltage for both the transmitter and vehicle prior to
operating your vehicle. Keep the batteries fresh in the transmitter and always begin
your vehicle runs with a fully charged battery pack.
2.3 Always check that the motor and servo are operating smoothly and in the right
direction prior to operation. If binding between components is observed, replace
parts as necessary to reduce possibility of component or servo damage.
2.4 To turn on your vehicle, always power on your transmitter first, then power on
your receiver.
After operating your radio-controlled model
3.1 To turn off the vehicle, always power off your receiver prior to powering off
your transmitter.
3.2 Use caution when handling the vehicle- components, especially the ESC and
motor which will be hot after operation.
3.3 Never use battery packs which are dented or otherwise damaged. Ensure that the
wire insulation is intact and that connectors are properly soldered.
Lithium batteries can become fire hazards if mishandled.

Table of Contents