Translation of the original operating instructions
5.2 Check the fuel level
1. Check the fuel gauge (no. 16) and fill the fuel tank if
the fuel level is too low.
Use unleaded petrol with min. 90 octane rating
(E10 is also suitable).
2. Remove the tank cap (no. 2).
3. Fill with fuel to a maximum level of the bottom of the
filter insert (no. 24).
4. Close the tank cap (no. 2).
5.3. Starting the engine
1. Disconnect all
consumers from the
AC connection
(no.13), as well as
the 12 V connection
(no.14) and switch on
the start/stop switch
(no.11).
2. Set the fuel cock (no. 8) to "ON".
3. Set the choke lever to "start".
4. Set the start/stop switch (no. 11) to "START".
5. Carefully pull the pull-cord starter until you can
feel a light resistance, then pull it more forcefully.
To Next Page
Loading...
