MAS-CABLE NTR 736
10.5
47.8
30.8
46
2500
89 750 101
MAS CABLE
RXD(RD)
TXD(SD)
DTR(ER)
GND(SG)
Module d’Automatisme Simple
NTR 736_M_MAS_CABLE_INTERFACE 06/1999 - 1/2
English
This manual contains text, diagrams and explanations which will guide the reader in the correct instruction
and operation of the MAS-CABLE interface. It should be read and understood before attempting to install or
use the unit.
Further information can be found in the MILLENIUM Installation Manual NTR 735 and the Programming
Manual NTR 737.
Don’t touch
1. Introduction
The MAS-CABLE is an RS232C interface connected between a MILLENIUM series controller and a personal
computer for a programming tool.
Note :
• MAS-CABLE interface cannot be used for any other applications.
• MAS-CABLE interface rises about 40 mm above the top panel when connecting to a MILLENIUM series
controller.
1.1 External dimensions
MILLENIUM
series side
Personal computer
side
(9 pin D-SUB)
* Set this signal
to high-level.
Dimensions in mm.
To Next Page
Need help?
General