temperature of the water in the boiler, but it does not mean the unit will stop operating, you may continue to
make coffee regardless of it.
5.You should turn the knob to the “ ” position manually when desired coffee is obtained or the colour of
coffee changes weak obviously,your coffee is ready now.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you need operate
manually sometimes!
6. After finishing making the coffee, you can take the metal funnel out through turn clockwise, then pour the
coffee residue out with the steel mesh pressed by press bar.
7. Press the power switch to cut off the power source.
8. Let them cool down completely, then rinse under running water.
FROTHING MILK/ MAKE CAPPUCCINO
You get a cup of cappuccino when you toping up a cup of espresso with frothing milk.
Method:
1、Prepare espresso first with container big enough according to the part “MAKE ESPRESSO COFFEE”,
make sure that the knob is at the “ ” position.
2、Press down the steam button to the lower position which is the “ ” position, waiting for until the
ready indicator (yellow) is illuminated.
Note: During continuous operations, the ready indicator is likely to extinguish due to the inadequate
temperature of the water in the boiler, but it does not mean the unit will stop operating, you may continue
to make cappuccino regardless of it.
3
、
Fill a jug with about 150 grams of milk for each cappuccino to be prepared, you are recommended to
use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and bear in
mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
4
、
Insert the steam wand(with the frothing device) into the milk about two centimetre, then turn the knob to
the “ ” position , steam will come out from the steam wand. Froth milk in the way moving vessel
round from up to down.
5. When the required purpose is reached, you can turn the knob to the“ ” position.
Note: Clean steam outlet with wet sponge immediately after steam stops generating, but care not to hurt!