EasyManua.ls Logo

Crown DWC 4504A WH - User Manual

Crown DWC 4504A WH
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Dishwasher / User Manual
EN
DWC 4504A WH / DWC 4507A SL
®

Table of Contents

Questions and Answers

  • M
    Melissa ReyesAug 15, 2025
    Why is my Crown DWC 4504A WH programme not starting?
    • A
      Alexis AlvarezAug 15, 2025
      There are several reasons why your Crown Dishwasher programme might not be starting: * The dishwasher may not be plugged in. Ensure it is properly plugged in. * The dishwasher may not be switched on. Press the On/Off button to switch it on. * A fuse may have blown. Check your indoor fuses. * The water inlet tap may be closed. Turn on the water inlet tap. * The dishwasher door may be open. Close the dishwasher door. * The water inlet hose and machine filters may be clogged. Check the water inlet hose and machine filters to ensure they are not clogged.
  • M
    Matthew SuttonAug 18, 2025
    What to do if water remains inside my Crown DWC 4504A WH Dishwasher?
    • C
      Courtney Simpson MDAug 18, 2025
      If water remains inside your Crown Dishwasher, consider the following: * The water drain hose might be clogged or twisted. Check the drain hose, and either clean or untwist it. * The filters might be clogged. Clean the filters. * The programme might not be finished yet. Wait until the programme is finished.
  • V
    Vincent AndrewsAug 21, 2025
    What to do if my Crown Dishwasher stops during washing?
    • S
      Susan ClarkAug 22, 2025
      If your Crown Dishwasher stops during washing, it could be due to: * A power failure. Check the mains power. * A water inlet failure. Check the water tap.
  • R
    Robert CooperAug 25, 2025
    Why does my Crown DWC 4504A WH Dishwasher have whitish stains on dishes?
    • M
      Michael GlassAug 26, 2025
      Whitish stains on dishes in your Crown Dishwasher can be caused by: * Not using enough detergent. Use the correct amount of detergent, as instructed in the programme table. * Rinse aid dosage and/or water softener setting set too low. Increase rinse aid and/or water softener level. * High water hardness level. Increase water softener level and add salt. * Salt compartment cap not closed properly. Check that the salt compartment cap is closed properly.
  • K
    Kristopher AndersonAug 28, 2025
    How to fix rust stains on dishes from my Crown DWC 4504A WH Dishwasher?
    • M
      Michelle RamirezAug 28, 2025
      Rust stains on dishes from your Crown Dishwasher may be due to: * Insufficient stainless-steel quality of the dishes. Use only dishwasher-proof sets. * High level of salt in wash water. Adjust the water hardness level using water hardness table. * Salt compartment cap not closed properly. Check that the salt compartment cap is closed properly. * Too much salt spilled in the Dishwasher while filling it with salt. Use a funnel while filling salt to the compartment to avoid spillage. * A poor mains grounding. Consult a qualified electrician immediately.
  • A
    Aaron HillAug 31, 2025
    Why are there food wastes on dishes after using my Crown DWC 4504A WH Dishwasher?
    • H
      Henry MillsAug 31, 2025
      If partial food wastes remain on the dishes after using your Crown Dishwasher, it could be because: * Dishes are placed incorrectly, preventing sprayed water from reaching affected dishes. Do not overload baskets. * Dishes are leaning against each other. Place dishes as instructed in the section on loading your dishwasher. * Not enough detergent is used. Use the correct amount of detergent, as instructed in the programme table. * The wrong wash programme was selected. Use the information in the programme table to select the most appropriate programme. * Spray arms are clogged with food waste. Clean the holes in the spray arms with thin objects. * Filters or the water drain pump are clogged, or the filter is misplaced. Check that the drain hose and filters are correctly fitted.
  • S
    Scott WilliamsSep 4, 2025
    Why won't my dishes dry in my Crown DWC 4504A WH Dishwasher?
    • N
      norma14Sep 4, 2025
      If your dishes do not dry in your Crown Dishwasher, it may be because: * The drying option is not selected. Select a programme with a drying option. * The rinse aid dosage is set too low. Increase the rinse aid dosage setting.
  • Y
    ymilesSep 7, 2025
    Why is my Crown DWC 4504A WH making shaking and hitting noises?
    • D
      Denise MartinSep 7, 2025
      If you hear shaking and hitting noises during a wash operation of your Crown Dishwasher, it is likely that the spray arm is hitting the dishes in the lower basket. To solve this, move or remove the items blocking the spray arm.
  • M
    martinmarySep 12, 2025
    Why does detergent remain in the compartment of my Crown Dishwasher?
    • J
      Jared ZhangSep 12, 2025
      If detergent remains in the detergent compartment of your Crown Dishwasher, it is likely because detergent was added when the detergent compartment was wet. Make sure the detergent compartment is dry before use.

Crown DWC 4504A WH Specifications

General IconGeneral
TypeFreestanding
Capacity12 place settings
Energy RatingA++
Noise Level49 dB
Weight45 kg
ColorWhite
Child lockYes
Delay start (hours)1-24 hours