Crunch CS35CX - Speaker Location and Mounting Tips; Factory Speaker Replacement Installation; Custom Speaker Location and Installation

2
SPEAKERLOCATION ANDMOUNTINGTIPS
THEFIRSTSTEP ISTHOROUGHPLANNINGBEFORETHE
INSTALLATIONBEGINS.
THESPEAKERSCREWHOLECONFIGURATIONWILL WORKWITH
MOSTDOMESTIC ANDFOREIGNVEHICLES.
FOLLOWTHESEINSTRUCTIONSCAREFULLY TOENSUREPROPER
IMAGING ANDMAXXIMUMPERFORMANCE.
1.Beforeyoualterthevehicle’sinteriormaterials,besurethereis
adequateroomandclearanceforthespeakerdepthtoclearthe
windowsandothermovingparts.(Seespeakermeasurementpage).
2.Ifyouareusingthespeakerwiresprovidedinthiskit,besure
toroutewiresthroughthefactorydoorgrommetasshowninthe
speakermountingdiagram.
3. Aftersecuringthespeakerandcheckingclearances,connect
thered/blackspeakeraudiowirestothecorrectspeaker+and-
spadeterminals.
1.Followsteps1-5above.
2.Usethespeakermountingdiagramsandspeakerholecut-out
dimensionsonthefollowingpages.
3. Alwaysmounttheleftandrightsidespeakersonthesameplane.
Thismeansthateachspeakershouldbethesameheightfrom
thefloorandsamedistancefromthefirewall.Donotmountone
speakerhigher,lower,furtherforwardorfurtherbehindtheother.
FactorySpeakerReplacementLocationandInstallation
CustomSpeakerLocationandInstallation