EasyManua.ls Logo

CRUSSIS CROSS Series - User Manual

CRUSSIS CROSS Series
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Seřízený představec řádně dotáhněte.
Dotahovací moment 4 Nm
Installation instructions for kick scooters - series CROSS
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
Step 8.
Step 9.
Step 10.
Step 11.
Step 12.
Make sure that cartoon is not damaged
Remove the kick scooter out of the box
Remove the tape holding front and
rear wheel
Remove the protecting material from frame
Remove the protecting material
from handlebars
Put wheels aside
Loosen the screws on the stem
and align so that it faces forward while riding
In this step set the direction
of the stem roughly.
You will align it precisely later with the wheel on
Tighten the screws on the stem with force 4 NM
Remove the screws from the front part
of the stem
Attach the handlebars
Put back the front part of the stem
and lightly tighten, adjust the angle
of the handlebar and screw it with 4 NM
www.kickscooters-crussis.eu
Question and Answer IconNeed help?

Do you have a question about the CRUSSIS CROSS Series and is the answer not in the manual?

Summary

Kick Scooter Assembly Guide

Unpacking and Initial Inspection

Unpack the scooter and verify the shipping carton is not damaged.

Scooter Removal from Box

Carefully remove the kick scooter from its shipping box.

Front and Rear Wheel Preparation

Remove the tape holding the front and rear wheels.

Protecting Material Removal

Remove protective material from the frame and handlebars.

Wheel Storage

Place the wheels aside for later installation.

Stem Alignment and Tightening

Loosen stem screws, align it forward, and tighten securely with 4 NM.

Handlebar Attachment

Attach the handlebars to the stem and secure them.

Brake Pad Stopper Removal

Remove brake pad stopper; do not press lever until wheel is mounted.

Wheel Installation and Quick Release

Mount the wheel and properly tighten the quick release mechanism.

Final Alignment and Securing

Ensure stem and wheel form a single axis, then finalize tightening.

Handlebar Angle Adjustment

Adjust handlebar angle to suit brake levers, recommended at 45 degrees.

CRUSSIS CROSS Series Specifications

General IconGeneral
BrandCRUSSIS
ModelCROSS Series
CategoryScooter
LanguageEnglish