Safety
3-3
CAUTION
Mounting the cold head in an orientation other than vertical will void the warranty without prior written
authorization from Cryomech, Inc.
CAUTION
Alterations to the cryocooler are prohibited without prior written authorization from Cryomech, Inc.
Modifications without prior written approval will void the warranty.
Section 6.1.6 Connect the remote motor assembly’s flex line- Remote Motor Cold Heads Only
CAUTION
Follow this procedure carefully when connecting and disconnecting the helium flex lines. Failure to follow
the procedure will void the warranty.
CAUTION
Do not allow the flex lines to contact any corrosives or commercial cleaning agents. Flex line damage
caused by exposure to corrosives or commercial cleaning agents will not be covered by the warranty.
CAUTION
Applying extreme bend stress to a flex line will cause permanent damage. Bending a flex line to less than
a 12 in (30 cm) radius will void the warranty.
Section 6.2 Compressor installation
CAUTION
Failure to follow these installation guidelines could result in voiding the warranty.
Section 6.2.1 Prepare the compressor package location
WARNING
The helium compressor package must be positioned to provide easy access to the front panel mounted
circuit breaker.
Section 6.2.2 Connect the water lines to the compressor
CAUTION
Cooling water must meet the requirements in Section 5. Introduction of cooling water that does not meet
the specifications in Section 5, even for cleaning purposes, it will void the warranty.
CAUTION
Do not apply heat to the cooling water inlet and outlet connectors located on the front panel of the helium
compressor package.
To Next Page
Loading...