Crystal Mountain GLACIER User Manual (English)

Other manuals for Crystal Mountain GLACIER

Questions and Answers:

M
marissaperryAug 15, 2025
Why is the water from my Crystal Mountain Water Dispenser too warm when the compressor is running?
- T
  Theresa JohnsonAug 16, 2025
  If the compressor is running but the water from your Crystal Mountain Water Dispenser is too warm, consider the following: * The cold control might be set too low or be defective. Adjust or replace as necessary. * The refrigerant drier might be blocked. Replace the drier and recharge the system. * There could be a refrigerant leak. Recharge the system. * The evaporator band might not be tightened around the reservoir. Check that the evaporator is secure and latched.
C
Carla CollierAug 18, 2025
Why is the water in my Crystal Mountain Water Dispenser freezing?
- D
  Dawn WilliamsonAug 18, 2025
  If the water in your Crystal Mountain Water Dispenser is freezing, it could be due to: * The cold control being set too high or being defective. Adjust or replace as necessary. * The cold control sensing tube not being properly inside the evaporator. Reinstall accordingly. * An incorrect refrigerant charge (over charged). Recharge with the correct charge. * Not enough clearance at the rear of the cooler. Move the cooler away from the wall at least 3 inches.
J
Jeff MolinaAug 21, 2025
Why is the water from my Crystal Mountain Water Dispenser too cold when the compressor is running?
- J
  Joseph NunezAug 21, 2025
  If the compressor runs but the water is too cold in your Crystal Mountain Water Dispenser, it could be due to several reasons: * The cold control may be defective. Adjust or replace as necessary. * The cold control sensor may be incorrectly positioned. Reposition the sensing tube. * There might be a high refrigerant charge. Correct the charge. * The cold control could be set too cold. Adjust the cold control. * There might not be enough clearance at the rear of the cooler. Move the cooler away from the wall at least 3 inches.
L
lawsonstephanieAug 25, 2025
What to do if my Crystal Mountain Water Dispenser has no hot water but has cold water?
- E
  Edward WangAug 25, 2025
  If your Crystal Mountain Water Dispenser provides cold water but no hot water, consider the following: * The hot tank switch may be in the OFF position. Switch it to the ON position. * The hot tank reset might be tripped. Reset the button. * The hot tank cut out could be faulty. Replace the thermostat cut out. * There might be a break in the hot tank wires. Check the hot tank wiring diagram and secure accordingly. * The heater could be defective. Replace the heater. * There might not be enough water in the reservoir. Fill the reservoir. * The baffle cup might not be in place. Reinstall accordingly.
J
jcomptonAug 27, 2025
What to do if my Crystal Mountain Water Dispenser has no hot or cold water?
- R
  Robert RothAug 28, 2025
  If your Crystal Mountain Water Dispenser isn't dispensing any hot or cold water, consider the following: * The reservoir might be empty. Fill the reservoir. * There might be no power at the receptacle. Check the breakers. * There could be a break in the wiring system. Check the wiring diagram and fix the wires. * The water ways to the faucet might be blocked. Replace the reservoir.
T
Troy MckinneyAug 30, 2025
What to do if the Crystal Mountain Water Dispenser has an air lock causing no hot or cold water?
- V
  Valerie JimenezAug 30, 2025
  If your Crystal Mountain Water Dispenser has an air lock, resulting in no hot or cold water, check the floater in DryGuardTM to ensure it moves freely. Also, inspect the air filter; if it's wet, remove it and allow it to dry overnight.
A
Andrew HowardSep 2, 2025
What to do if my Crystal Mountain Water Dispenser compressor will not run?
- J
  Jonathan DelacruzSep 2, 2025
  If the compressor of your Crystal Mountain Water Dispenser isn't running, there are several potential causes: * There might be no power at the receptacle. Check the outlet and breaker for power. * The compressor relay or overload could be burnt out. Replace the relay or overload. * The cold control might be turned off. Adjust the cold control. * The cold control could be defective. Replace the cold control. * A wire might have come off a terminal or broken. Check the wiring diagram and secure the wire accordingly. * The power cord could be defective. Replace the cord.
A
Anna RussellSep 8, 2025
Why is my Crystal Mountain Water Dispenser so noisy?
- D
  david93Sep 9, 2025
  Excessive noise from your Crystal Mountain Water Dispenser can be attributed to several factors. Note that all refrigeration units emit some noise: * Compressor start up is normal. * Tubing rattles. Reposition the tubing inside the unit. * The compressor might not be securely mounted. Secure the mounting washers. * There could be loose screws. Tighten the screws. * The cooler may be damaged. Repair accordingly.
B
bentleymarkSep 12, 2025
What to do if water comes out of the faucet of my Crystal Mountain Water Dispenser but will not shut off?
- L
  Lisa ThompsonSep 12, 2025
  If water comes out of the faucet of your Crystal Mountain Water Dispenser but will not shut off, it could be due to: * Something stuck in the faucet. Remove any foreign object from the faucet. * A leaky seal in the faucet. Replace the faucet.

Crystal Mountain GLACIER Specifications

General

Brand	Crystal Mountain
Model	GLACIER
Category	Dispenser
Language	English

Crystal Mountain GLACIER Service Manual

Other manuals for Crystal Mountain GLACIER

Questions and Answers:

Crystal Mountain GLACIER Specifications