NOTE: Legislation only allows the call tone to be used once per minute, if the call button is
pressed more than once in a minute, the radio simply will not resend the call tone again.
Setting Call Tone
Press the “(MENU) button” four times, CA will on the LCD. Press the “DOWN button” or
“UP button” to select an option, “1-10”. Once the desired option has been selected, press
the “(PTT) button and this will save the selected channel and the radio will return to the
default screen.
FUNCTION- KEY TONE (TO)
Setting Key Tone (TO)
To access the TO feature, press the “(MENU) button” five times, “TO” will display on the
screen. Press the “UP button” or “DOWN button” to turn on or off. Once the desired
option has been selected, press the “(PTT) button” and this will save the selected option
and the radio will return to the default screen.
FUNCTION- ROGER BEEP
What is Roger Beep?
When the PTT is released after transmission, the radio will send a short beep to indicate
the transmission has finished. This is known as a roger beep.
Setting Roger Beep
To access the roger beep feature, press the “(MENU) button” six times, “RO” will display
on the screen. Press the “DOWN button” or “UP button” to select an option “on or off”.
Once the desired option has been selected, press the “(PTT) button” and this will save
the selected option and the radio will return to the default screen.
FUNCTION- REPEAT
What is Repeat?
Repeater stations allow your CB radio to operate over a greater distance (where your CB
has Duplex mode). The radio has repeat as default on.
Selecting Repeat
To access the repeat feature, press the “(MENU) button” seven times, “RP” will display
on the screen. Press the “DOWN button” or “UP button” to select an option “on or off”.
Once the desired option has been selected, press the “(PTT) button” and this will save
the selected option and the radio will return to the default screen.
To Next Page
Loading...
