Do you have a question about the CS Medical Systems TD-100 and is the answer not in the manual?
Explains safety signal words and provides definitions for terms.
Describes the TD-100 as an automated disinfector for TEE ultrasound probes.
Details physical dimensions, electrical, water, and drain requirements for the unit.
Discusses glutaraldehyde exposure limits and air filtration.
Outlines steps for shutting down the system in an emergency.
Explains what happens when a cycle is aborted and how to handle it.
Shows an example of a successful cycle printout and its components.
Illustrates the printout for an aborted or invalid cycle.
Provides contact information for troubleshooting assistance.
Addresses issues related to low water pressure errors.
Explains how the system checks for faults and generates error reports.
Lists common problems, their possible causes, and corrective actions.
Details daily inspection and cleaning procedures for the unit.
Provides step-by-step instructions for replacing the printer paper roll.
Guides on how to replace the air filter, including safety precautions.
Explains the procedure for setting or updating the system's date and time.
Summarizes key warnings and cautions for safe operation of the device.
Lists part numbers and descriptions for replacement components.
Provides contact details for the manufacturer, CS Medical.
| Manufacturer | CS Medical Systems |
|---|---|
| Disinfectant | TD-5 or TD-8 High-Level Disinfectant |
| Device Type | Automated TEE Probe Disinfector |
| Display | LCD |
| Power Supply | 50/60 Hz |
| Dimensions | 16.5" W |
| Description | The TD-100 Automated TEE Probe Disinfector is designed for the high-level disinfection of transesophageal echocardiography (TEE) probes. |
Loading...