CSI BRUTE Series - Instructions for In-Vehicle Use; Operation Method; Mode and Temperature Settings

4
(For California Residents)
WARNING: These products can expose you to chemicals including LEAD and DEHP which are known to the state of California to cause cancer and birth defects or other reproductive harm. For more
information go to www.P65WARNINGS.CA.GOV. Wash hands following installation or handling.
4. OPERATION METHOD
• Connect to the power source, press the ON/OFF
button for 3 seconds to show inner temperature
and start the compressor to enter cooling mode
• Press the ON/OFF button for 3 seconds to turn the
refrigerator/freezer off
• Only 1 temperature will display if the inner middle plate
has been removed
• To change mode settings, press the gear button
ECO (energy saving mode) or MAX (fast cooling
mode). MAX is the factory setting.
• Press the + or - buttons to set the temperature between 50
o
F to -4
o
F
(10
o
C to -20
o
C)
INSTRUCTIONS FOR IN-VEHICLE USE
• The refrigerator has a 3-level battery protection function, which not only guarantees the normal
operation of the refrigerator but also protects the battery of the vehicle. When in the power-on
 state,presstheSETbuttonfor3secondsandthedisplayscreenashesH.Selectlowvoltage
protection L (low), M (medium) and H (high) by pressing the SET button. The factory defaults to
H (high) protection.
• H (high) should be set when the refrigerator is connected to the car power and M (medium)
or L (low) should be set when it is connected to a portable backup battery. Because of the different
output voltage between different vehicles, the battery gear can be set from H (high) to M (medium)
or M (medium) to L (low) if there is a voltage protection code F1 displayed on the panel. The
battery gear should be set to H (high) if the refrigerator needs to keep working after turning off the
car engine and to avoid the possibility of overuse or draining the battery to the point where the
vehicle cannot be restarted.